We set a small cookie for sign-in (strictly necessary), one to remember your language when you pick one (strictly necessary, set only at your request), and one for generation deduplication (only with consent). No third-party advertising or tracking cookies. See our Privacy policy for details.
One wall station for all your ride gadgets. Pick up to five bays, left to right, and the plate sizes itself (up to 250 mm): a Garmin Edge dock with the real quarter-turn interface (Edge 130-1050 click in upright, USB-C reachable from below), a stand-off arm that parks a Garmin Varia radar on its side so its charging flap stays reachable, a Wahoo ELEMNT dock with Wahoo's own rotated wider-tab socket, a rounded hook for open-ear headphones, a tilted tray for earbud cases, and a wide trough for a headlight. An optional cable channel along the bottom rail snaps your charging cables in; screw holes are optional too - leave them off and glue the flat back to the wall. Prints in one piece with no supports.
Leftmost bay. Bay widths: Garmin Edge dock 64 mm, Varia arm 48 mm, Wahoo dock 68 mm, hook 40 mm, earbuds tray 78 mm, light trough 130 mm - the plate is their sum plus 4 mm margins, capped at 250 mm.
Second bay from the left ('Empty' skips it and the plate shrinks).
Third bay from the left.
Fourth bay from the left.
Rightmost bay.
Cable run along the bottom rail: a tall snap-in channel (push each cable up through the 4.2 mm slit) with a dedicated exit at every bay - a notch and snap clip below the docks and hook, and a hidden riser that surfaces inside the tray and light trough. One cable per device, no threading.
Where the charging cables enter the rail, as you face the station - pick the side your power outlet is on. Right or left leaves that end of the channel open and caps the other; center caps both ends and opens an intake mouth underneath the middle of the rail.
Countersunk holes for #6-#8 (3.5-4 mm) wood screws. Turn off for a clean plate you glue or tape to the wall (use ~60 cm2 of VHB or two large Command strips).
